Biodiesel Production from Sudanese Jatropha curcas Seed by The Alkali-Catalyzed Transesterification Process and Its Analysis by Gas Chromatography
Abstract
Sudan is highly dependent on diesel. Diesel is used in agriculture machines, transportation, and other applications. This study has been carried out to produced biodiesel from Jatropha curcas seed oil. Jatropha was chosen because it is not edible, therefore it will not pose a new problem to humans regarding food competition. This research successfully extracted oil from Jatropha curcas seed using n-hexane solvent with yield 39%. The oil than converted to biodiesel by alkaline transesterification process with a conversion yield 92 %. The properties such as flash point, acid value, viscosity, iodine value, density, copper corrosion, cetane number, sulphated ash, pour point, free glycerol, and total glycerol contents were 174 oC, 0.17 mg KOH/g, 8.912 mm2/s, 102 g I2/100 g, 895.8 kg/m3, class1, 51, 0.0047 %, -3 oC, 0.01 %,0.03 %, respectively. These quantities obtained were met most of the biodiesel standards that are ASTM D6751, EN14214, and ASTM D975. The GC data showed the fatty acid methyl ester (FAME) has a 12-20 carbon chain and still has monoglycerides, diglycerides, and triglycerides.
Keywords
References
F. Ma and M. A. Hanna, Biodiesel production: a review1,†Bioresour. Technol., vol. 70, no. 1, pp. 115, 1999.
M. Y. Koh and T. I. Tinia, A review of biodiesel production from Jatropha curcas L. oil,†Renew. Sustain. Energy Rev., vol. 15, no. 5, pp. 22402251, 2011.
R. Abdulla, E. S. Chan, and P. Ravindra, Biodiesel production from Jatropha curcas: A critical review,†Crit. Rev. Biotechnol., vol. 31, no. 1, pp. 5364, 2011.
S. Sivaprakasam and C. G. Saravanan, Optimization of the transesterification process for biodiesel production and use of biodiesel in a compression ignition engine,†Energy and Fuels, vol. 21, no. 5, pp. 29983003, 2007.
Maftuchah, A. Zainudin, A. Winaya, and Y. Rahmadesi, Biodiesel generated from Jatropha (Jatropha curcas Linn.) seeds selected based on various genotypes crossbred,†Energy Reports, vol. 6, pp. 345350, 2020.
K. Shrestha, J. R. Ghimire, and M. B. Gewali, Biodiesel Production from Jatropha curcas (L.) Oil of Nepal by Transesterification Process,†Int. J. Pharm. Chem. Biol. Sci., vol. 3, no. 3, pp. 603609, 2013.
F. Ahmed, S. O. Giwa, M. Ibrahim, and A. Giwa, Production of biodiesel from Jatropha curcas seed oil using base catalysed transesterification,†Int. J. ChemTech Res., vol. 9, no. 6, pp. 322332, 2016.
A. N. Dias et al., Evaluation of ASTM D6584 method for biodiesel ethyl esters from sunflower oil and soybean/tallow mixture and for biodiesel methyl esters from tung oil and soybean/tung mixture,†J. Braz. Chem. Soc., vol. 25, no. 7, pp. 11611165, 2014.
CEN/TC 307, EN 14107 Fat and oil derivatives - Fatty acid methyl esters (FAME) - Determination of phosphorus content by inductively coupled plasma (ICP) emission spectrometry,†2003.
CEN/TC 307, EN 14103 Fat and Oil Derivatives - Fatty Acid Methyl Esters (Fame) - Determination of Ester and Linolenic Acid Methyl Ester Contents,†2020.
ISO/TC 28, ISO 3679 Determination of flash point - Method for flash no-flash and flash point by small scale closed cup tester,†2022.
CEN/TC 307, EN 14111 Fat and oil derivatives - Fatty Acid Methyl Esters (FAME) - Determination of iodine value,†2022.
ISO/TC 28, ISO 20846 Petroleum products - Determination of sulfur content of automotive fuels - Ultraviolet fluorescence method,†2019.
ISO/TC 28, ISO 2160 Petroleum products - Corrosiveness to copper - Copper strip test,†1998.
ISO/TC 28/SC 2, ISO 12937 Petroleum products - Determination of water - Coulometric Karl Fischer titration method,†2000.
ISO/TC 28/SC 2, ISO 3675 Crude petroleum and liquid petroleum products - Laboratory determination of density - Hydrometer method,†1998.
ISO/TC 28, ISO 3987 Petroleum products - Determination of sulfated ash in lubricating oils and additives,†2010.
ISO/TC 28, ISO 3104 Petroleum products - Transparent and opaque liquids -Determination of kinematic viscosity and calculation of dynamic viscosity,†2020.
CEN/TC 307, EN 14104 Fat and oil derivates. Fatty acid methyl ester (FAME). Determination of acid value,†2021.
ISO/TC 28, ISO 5165 Petroleum products - Determination of the ignition quality of diesel fuels - Cetane engine method,†2020.
CEN/TC 19, EN 14214 Liquid petroleum products - Fatty acid methyl esters (FAME) for use in diesel engines and heating applications - Requirements and test methods,†2019.
ASTM Internasional, ASTM D97 Standard Test Method for Pour Point of Petroleum Products,†in ASTM Volume 05.01: Petroleum Products, Liquid Fuels, And Lubricants (I): C1234D3705, 2021, p. 7.
ASTM Internasional, ASTM D1160 Standard Test Method for Distillation of Petroleum Products at Reduced Pressure,†in ASTM Volume 05.01: Petroleum Products, Liquid Fuels, And Lubricants (I): C1234D3705, 2021, p. 20.
ASTM Internasional, ASTM D93 Standard Test Methods for Flash Point by Pensky-Martens Closed Cup Tester,†in ASTM Volume 05.01: Petroleum Products, Liquid Fuels, And Lubricants (I): C1234D3705, 2021, p. 18.
ASTM Internasional, ASTM D4530 Standard Test Method for Determination of Carbon Residue (Micro Method),†in ASTM Volume 05.02: Petroleum Products, Liquid Fuels, And Lubricants (II): D4177 D6468, 2021, p. 7.
ASTM Internasional, ASTM D5453 Standard Test Method for Determination of Total Sulfur in Light Hydrocarbons, Spark Ignition Engine Fuel, Diesel Engine Fuel, and Engine Oil by Ultraviolet Fluorescence,†in ASTM Volume 05.02: Petroleum Products, Liquid Fuels, And Lubricants (II): D4177 D6468, 2021, p. 12.
ASTM Internasional, ASTM D130 Standard Test Method for Corrosiveness to Copper from Petroleum Products by Copper Strip Test,†in ASTM Volume 05.01: Petroleum Products, Liquid Fuels, And Lubricants (I): C1234D3705, 2021, p. 10.
ASTM Internasional, ASTM D2709 Standard Test Method for Water and Sediment in Middle Distillate Fuels by Centrifuge,†in ASTM Volume 05.01: Petroleum Products, Liquid Fuels, And Lubricants (I): C1234D3705, 2021, p. 3.
ASTM Internasional, ASTM D1298 Standard Test Method for Density, Relative Density, or API Gravity of Crude Petroleum and Liquid Petroleum Products by Hydrometer Method,†in ASTM Volume 05.01: Petroleum Products, Liquid Fuels, And Lubricants (I): C1234D3705, 2021, p. 8.
ASTM Internasional, ASTM D874 Standard Test Method for Sulfated Ash from Lubricating Oils and Additives,†in ASTM Volume 05.01: Petroleum Products, Liquid Fuels, And Lubricants (I): C1234D3705, 2021, p. 5.
ASTM Internasional, ASTM D445 Standard Test Method for Kinematic Viscosity of Transparent and Opaque Liquids (and Calculation of Dynamic Viscosity),†in ASTM Volume 05.01: Petroleum Products, Liquid Fuels, And Lubricants (I): C1234D3705, 2021, p. 17.
ASTM Internasional, ASTM D664 Standard Test Method for Acid Number of Petroleum Products by Potentiometric Titration,†in ASTM Volume 05.01: Petroleum Products, Liquid Fuels, And Lubricants (I): C1234D3705, 2021, p. 11.
ASTM Internasional, ASTM D613 Standard Test Method for Cetane Number of Diesel Fuel Oil,†in ASTM Volume 05.05: Petroleum Products, Liquid Fuels, And Lubricants (V): D8144 Latest; Combustion Characteristics; Manufactured Carbon And Graphite Products, 2021, p. 19.
ASTM Internasional, ASTM D4737 Standard Test Method for Calculated Cetane Index by Four Variable Equation,†in ASTM Volume 05.02: Petroleum Products, Liquid Fuels, And Lubricants (II): D4177 D6468, 2021, p. 5.
ASTM Internasional, ASTM D6751 Standard Specification for Biodiesel Fuel Blend Stock (B100) for Middle Distillate Fuels,†in ASTM Volume 05.03: Petroleum Products, Liquid Fuels, And Lubricants (III): D6469 D7398, 2021, p. 11.
ASTM Internasional, ASTM D975 Standard Specification for Diesel Fuel,†in ASTM Volume 05.01: Petroleum Products, Liquid Fuels, And Lubricants (I): C1234D3705, 2021, p. 28.
DOI: 10.33751/helium.v2i2.6338
Abstract views : 189
views : 112
Refbacks
- There are currently no refbacks.
